Stand Information
What do I get with my Stand?
All outdoor stands are supplied with 1 x powerpoint unless otherwise specified on your contract.
All other stands – the allocation of power and lights is based on your stand size.
|
Carpet Colour |
Type |
Panel Colour |
Type |
Hall 1 |
Ebony |
Tile |
Coal |
Corinthian |
Hall 2 |
Ebony |
Tile |
Coal |
Corinthian |
Hall 3 & 4 |
Ebony |
Tile |
Coal |
Corinthian |
Hall 5 |
Burgundy |
|
Coal |
Corinthian |
Hall 6 & 7 |
Exhibition Grey |
Roll |
Coal |
Corinthian |
Hall 9 |
Exhibition Grey |
Roll |
Black |
Corinthian |
Hall 10 |
Exhibition Grey |
Roll |
Coal |
Corinthian |
All panels are Velcro compatible front runner fabric. Signage can be attached to the frontrunner panels by using non-fluffy Velcro strips or dots. Thumb tacks, nails, screws, painting or permanent marking on these panels is not permitted – damage will be charged to the exhibitor.
Corinthian coal panels are 45mm thick, Corinthian black panels (only in Hall 9) are 35mm thick.
The panels are all 2.3m high, if you are planning to custom build your stand, all stands above panel height will need to contact Shannon Gallagher on 09 9768307 or 021 619 902 in which to discuss Council Permits.
Hanging of Art – There is a special hook that can be used to hang art. This hook is hung on top of the panel. Please contact Sharon Reedy at Displayworks/ Exhibition Hire Services to purchase Hooks on 09 579 9884 or
Please also note: These fittings are not included on any outdoor sites.
Change of colour Panels and Carpet –If you wish to change the colour of your Panels or Carpet, please complete the
Panel/Carpet form » There is a small fee for this service. If you do not require carpet on your stand, please contact Shannon Gallagher on 09 976 8307 or 021 619 902, email:
Floor Loading - Hall 1 - 4
Floor Loadings Halls 1- 4 – Maximum point or strip distributed weight – 2000 lb/sq ft
Average weight 500 lb/sq ft; Maximum vehicle weight 8 tonne.
Floor Loadings on Temporary Halls
NO VEHICLES OR FORKLIFT IN STRUCTURES AT ANY TIME!
Additional Stand Requirements & Services
Panels & Carpet
For a change in panel or carpet colour, additional panels, equipment hire etc please contact:
For a change in panel or carpet colour, additional panels, equipment hire etc. please contact: Sharon Reedy |
![]() |
Furniture Hire
Equipment Hire Catalogue & Order Form » [4mb pdf]
Electrical Requirements
| For additional power or lighting please contact: Reuben Mansfield Show Light & Power PO Box 83-148, Edmonton, Auckland Ph: 09 828 8844 ext 4 Fax: 09 828 8841 Mobile: 021 810 210 Email: |
- Exhibitors are free to make arrangements with their own electrical contractors, however all electrical connections to mains supply must be supervised by our on-site Electrical contractors to avoid overloading.
- 3 Phase Power – Anyone requiring 3 Phase Power or heavier than normal domestic power, i.e. 10 amp supply, must contact Show Light & Power.
Forklifts
There will be forklifts onsite during build-up and breakdown for exhibitor’s use. This service includes loading and unloading of equipment. There is no charge for this service provided that it is a straight lift on and off to and from your stand. If the forklift is required for longer, there will be a cost charged by the ½ hour. Rate to be advised.
The forklift service is on a first come, first served basis. Please come to the Show Information desk, main foyer of the venue during build up and breakdown to book the forklift service.
Banner Hanging
Please contact Jim Thomson if you require a scissor lift or someone to hang banners for your stand. Jims Contracting, Jim Thomson on 0274 397 716 or
| Additional Services Here » |


